RSS™ JTS

Designed For Joists and Trusses

 

- Interior / Exterior Use

         - Ledger Board
         - Retaining Walls
         - Log & Timber Framing

 - No Pre-Drilling Unless Material Requires

 - Lag Screw Alternative

 - Built In Washer Head

 - CEE Thread Enlarges Hole for Improved Drawing Strength

Download Tech Bulletin

GRK’s Joist and Truss Screw is the ideal fastener for heavy duty roof and floor construction. GRK’s RSS™ Rugged Structural Screw is made of specially hardened steel to provide you with high tensile, torque and shear strength.

The sharp threads and points bite instantly into the material (including hardwood), reducing the splitting effect due to smaller shanks. RSS™ JTS screws have a six threaded CEE thread that enlarges the screw hole for the non-threaded portion of the fastener, allowing the wood to settle easily and increasing the screw’s drawing strength.

The CEE thread also reduces the likelihood of splitting the wood and the friction on the screw shank which can result in lowering the driving torque. Our round head with built-in shield (washer type head) has no sharp edges such as on conventional lag screws.

The added shoulder (nominal diameter) underneath the washer has the ability to center the RSS™ screw in pre-drilled hardware like hinges and connector plates. Short lengths of the RSS™ may also be used to install wire diamond mesh for stucco buildings.

 

Mobile Version | Standard Version